The KM3's look sooooo good, and they preform well on dirt but.......the tread wear has been horrendous. I have about 14,000 miles on them and they cup so bad. I have some knobs that don't even touch the ground. I have to rotate them every 2000 to 4000 miles other wise the treads get so cupped out that the truck vibrates. I can feel each tread lug knocking on the asphalt. I even had my truck realigned just to eliminate that as a possible cause for the early wear and I still only got a couple thousand miles out of them after a fresh alignment before I had to rotate the tires again. The tread overall has worn out fast and is noticeably smaller also. Really disappointed and not sure where to go from here with these.

I bought a full set of 5 for my Rubicon. I went with the LT315/70R17/ E 121Q tires. I wanted 35 inch tires and the Goodrich website stated these tires at 34.4 inches. I thought that was close enough. Got my tires and drove them for a bit and then thought I would just check the tire height. Imagine my surprise when I measure them fully inflated (37psi) at 33.0 inches even. Not even close to the 34.4 stated on the website. Love the tires, but wanted the tire height.

Good in mud and loose soil. Terrible in snow and always get irregular wear well before the tread is used up, even with frequent rotation and alignments. These wear my second set and I will not be purchasing a third set and going with a competitive tire company.

I have had these tires on my 2013 Jeep wrangler Rubicon for 20,000 miles. They are the best tires I have purchased for on and of the road performance. On road performance they have great traction is Rain and Snow. Off-road performance these tires are great under pressure and when needed. I have used the tires on countless rock crawling trips and absolutely no complaints. Not too loud cruising down the highway (70mph) for a Mud-Terrain tire.

Spent a week driving the new Jeep Wrangler JL with the new 35” KM3. Recommended psi is 40 I believe or at least that what psi was in them. At 40 a little hard & noiser. Dropped to 32 psi & loved the ride & noise was not an issue. Is did tread to surface test & had full tread coverage. Did some off road running tires @15 & had fantastic traction!

I bought these for my 2017 Colorado ZR2 in 285/70/17 (E load) when they first came out in June of 2018. Overall, I got 66,000 miles out of them. They could have gone another 5k miles or so, but I believe I potentially got a slightly defective tire, as it has worn unevenly and is not perfectly round. Thus, there is now too much vibration to continue driving on this set. The other three tires in the set have worn and performed perfectly. The worst of the tires is pictured below. I always rotated the tires during oil changes. However, I elected to live with the “bad” tire and it was fine. It only became a problem in the last month due to the vibrations in the cab and steering wheel because of the imperfect shape. This was a very early set of KM3s so I’m not upset or surprised by this, as I think it is bound to happen. I took these tires to MOAB and on other off-road trails and they were very tough and had great traction. I’m giving 4 stars because the on-road ride quality leaves a bit to be desired, between the noise and vibration I experienced. I have since moved from CA to CO and need better snow traction. So I swapped out the KM3s for KO2s. Sticking with BFGoodrich!!! Don’t let my story stray you from these tires. Overall, they were awesome! I just have different needs now. I would also recommend a C load rating if you drive a smaller vehicle like mine. The E was a bit stiff for my truck (running at 38 psi).

Bought two years ago, and have less than 15k miles and tires are already worn down to less than 40% life. Website advertises BFG KM3 50k/6yr warranty and when filing warranty claim advised they do not have such coverage, false advertising. Drive my truck 2-3 time per week for mountain trips/hunting/camping, no serious or egregious off roading, tires performed decent on off road trails/backroads but poor materials due to such quick wear. Inspection report advised tire bands are bad as well. Second set of BFGs, first K02 and second chance KM3, 9/10 do NOT recommend either. After calling warranty number and being placed on hold was sent to a survey after an extended period of time then call terminated.

I bought 35x12.50r17 almost a year ago. Two tires wore out horribly and uneven. The other two are half tread or better. I installed all new suspension in shocks a month prior to installing my tires. Rotated every oil change. Was not pleased with the wear of those two tires. Have since sold them to try and make my money back for another set. I just ordered 39x13.50x17 for my truck now and they’re on indefinite back order. Really liked the look and performance, so I went with the KM3 again in a larger size. I hope these ones wear fine, and are put into production soon!

I bought a set of tires 37's for the Rubicon (2x), Dusy Ershim, and Fordyce. I have an old Defender TDI about 4300lbs I used to drive them at 32psi but the wear on them to Dusy from SF robbbed the edge treads (sad) they are a soft compound. So i upped the PSI to 47-50, never had a problem on road in the summer (dry). Got a great amount of performance from them on the Granite, no punctures or side wall gouges over 80 old miles of rock crawling (6psi abused Lit momentum bumpin') and 12000mls of on road use. I highly recommend Driving these are a great compromise of crazy crawling, decent mudding, and highway reduced road noise.

Mostly because of the vid BFG made, showing the sidewall resistance to cuts and punctures. There are times when you cannot change a flat, cannot even stop, cannot avoid something sharp, and are fully loaded or grossly overloaded. When it's life and death. What's an extra hundred per tire against that? Others may be as good, but where's the video proof?