Easy to install. The provided self thread screws made project easy. Recommended tools are screw drivers (cordless) tin snips. I also needed hack saw for tight cuts in a few areas. Many leaves have fallen and works great!

Very easy to install if you are handy with a tin snips and a cordless drill/driver. Very impressed with the quality and functionality. we have had some very heavy rains lately and the amount of water that flowed across the gutter guard was very minimal. Very happy with the performance of these gutter guards.

Easy? Well yes but you you will have to manuplate the shingles to raise them to slide the guard under ,I found it better to bend the right angle first then side under. The woest was my ladder was always in the wrong position and would have to be moved so as to properly slide in the guard and align

The leaf guards were a perfect fit, only one cut around a gutter mitre. The shipping took a minute, but they did arrive and came well secured in an appropriate box, delivered to my front door. I installed 28ft. , didn't take much effort, just up and down a ladder a few dozen times...

I installed 120 ft of the Gutter Glove in about 2 1/2 hours. We have had 3 good hard rains since and results are super. I may need to install a valley diverter to help direct the valley water. Otherwise this is best product yet. They replaced LEAFGUARD GUTTERS!

The provided instructions covered the steps required to put these onto my gutters and they went on just fine with a barrel tile roof. The biggest challenge is cutting through the aluminum channel that will rest on top of the gutter since it is shaped to have a drop-down stop of aluminum, like a rudder, that rests against the inner edge of your gutter when installed, but makes it tough to cut with metal shears. Getting them bent to properly cover the gutter and rest against the back, just below the barrel tile roof extensions does take a little bit of work. Apart from that, installation went pretty easy, and I've already seen a lot of tree debris that I'm getting protection from sitting on top of the screens, so they seem to really do the job, and I expect them to last for a long time since they are made from SS and aluminum.

The installation was extremely easy. Two men, handy-toes, installed 340 feet of gutter guards in less than 8 hours. They look great. If it was sins hard some of the water rolls off of the sid rather than going into the gutter. Other than that, they are great.

They say it fits 6 and 7 in gutters but does not fit the style on a manufactured home along the Lanai or screen room here in Florida unless you spend hundreds of dollars to put covers over the aluminum pans that make up the roof. All in all it a good product, similar to the product they wanted 3600$ dollars for.

Great quality & material. Biggest gripe is w/ roof pitch >6. After bending especially when it is necessary in the direction into gutter. The back thinner width extrusion w/ the small lip doesn’t provide 1/4” nut driver tool clearance for driving screw nor screw head clearance , screw head sits on top of lip & it’s short length does not provide enough screw thread engagement into fascia board. Also, not enough screws for (6) screws per section for this type of installation.

If your roof pitch is less than 6, this might be a good product. If your roof is more than a 6 pitch, the devices have to be bent/modified for the excessive pitch. It was not worth my time to bend. If I had a brake, I maybe would have tried.