lights are very bright, light weight and easy to hang. Just what I was expecting them to be

Very bright and easy to install

Excellent value. Light weight and very bright.

Nice shop light for garage

LED Shop Light

Bright

I purchased 3 of these lights last summer. One of them has a section of LEDs that are dead. Unsure what is wrong for sure, but support has been non-existent. I've sent 2 emails(first at the end of Dec 2020) and another within the last week and no contact for either. Their "live phone support" is still unavailable, and left a voicemail over a month ago. So far, no contact from anyone. If you buy any, you might need to consider the 5 year warranty as a "good faith" gesture, but in reality not worth the paper it's written on. If something goes wrong, might as well consider it disposable.

Light uses a circuit board with SMD (miniature) components to regulate voltage. Unfortunately poor soldering of the power resistors caused the unit to fail. Reflowing the solder provided a temporary fix, but failed again. Basically the wrong type of resistor was used (a full size resistor should have been used), the heat generated during use was so great it unsoldered itself. Not worth spending any more time trying to repair. This should have lasted decades if designed correctly. I am waiting for the others I purchased to fail!

I put four of these in my garage less than a year ago and two of them have already failed. After researching on the 'net I found that others have the same problem. That is, the light just blinks. It is apparently a poor soldering joint inside somewhere. Honeywell is useless when you call them. I've been waiting for a replacement for over a month and another one has failed in the meantime. They're $20 because they're junk.

Over the last five years, I've purchased 10 units. They work great... for awhile. Of the ten, so far I've had three fail. That's a 30% drop out rate and I expected much better results when compared to the old fluorescents, and with LEDs, you cannot change the bulb. Yes they are lower power and my suspicion is they are not designed to withstand the conditions of my shop, which is an unheated garage that can occasionally get below the freezing point in winter.