I think this is a good product for the price. You'll easily spend another $100 for other brands of the same size cabinet. Sam's has the best price too. I bought four of these cabinets and can see the frustration others posted about the door alignment issues. When I assembled the first cabinet, I followed the directions to a T, but at the end the doors did not align and the right door wouldn't shut properly. I improvised, and for the following three, I instead loosely screwed in the BACK panels, then waited to install the top front corner and side brackets and instead installed the doors before installing the brackets and tightening the back panels as noted in the instructions (Installing the doors must be done without tightening all of the door hinge screws. Tighten the top screw just enough to hold the doors in place, then screw in the other screws just a couple of turns. This will allow you to adjust the doors up or down by unscrewing the top screw, adjusting, then tightening again to test door position and closure). Then once I was fairly certain the doors were lined up and closed properly, I secured all of the door hinge screws, carefully mounted the brackets and tightened up the back panel screws and the doors closed perfectly. I would buy these again, but would suggest the manufacturer change the directions slightly as the doors can be tricky if the cabinet is not square. TIP: Take your time with assembly - about 90 minutes or so. If you use a cordless drill (which I recommend to quicken the project) make sure the torque setting is very low to prevent mis-threading and possible screw breakage/bending any metal. There are straps at the top of the back of the cabinet to attach to the wall for safety which is nice, but I think as long as you weight the cabinet on the bottom there would be little chance of tipping. Wheels are extra large so easy to roll around, and look great. When assembling, protect the finishes by using the packaging styrofoam on the floor to assemble. Will update in the future if anything arises.

This cabinet is really nice. Bigger then I thought. Very well made. Saved $200 by assembling myself. Just take your time. I'm 74 and it took me about 6 hours, with a break in the middle, 1 screw at a time. Instructions are vague at times but all the holes lined to perfectly. There are a couple of places where 2 people make it easier.

Great buy! I use this along with the workbench and stool in my hobby/laundry room. I plan to purchase the 4 drawer cabinet on rollers that stores and fits neatly under the bench so I can use this area as my home office also. I use the large cabinet for laundry supplies and can also use it for office supplies. Looks expensive and is a great value.

I have bought a number of these cabinets. They are very well built, sturdy & what I like best is they are mouse proof! I keep all my extra food in here because mice are a problem, but they can't get into this cabinet. I love the looks of these cabinets. When you get the cabinets, it is an easy unpack & assembly. Great instructions, and they give you all the tools you need for assembly.

Package and Instructions were much better than I expected. This is a quality product, with no sharp edges, and well designed. Buy with confidence, these are worthy of any man’s garage and far nicer than any husky product I’ve seen. One thing to note, this comes with (3) shelves, (4) would be more ideal, maybe buy an extra If considering this

Verdict: I'm giving this two stars because I ordered two cabinets. Both had a dent on the same exact front facing panel! It wasn't from packaging because those panels are nested in the center of the box. It's from the factory. Meh: It takes some time to assemble this thing but expected. Pro: Tons of storage inside! Wheels are HUGE and heavy full cabinets can be pushed round easily!! They give you a few extra screws too which is nice. Usually you get shorted in modern products. And all the tools you'll need to install are included. Con: Because the side panels are not all one piece this thing is not as rigid as other brands (which all cost more too). Other con is the dented panels (see attached photos). And while the doors have magnets to pull them tight they still are not seamless when they close. For example on mine the bottom sticks out. Again I chalk this up to the low rigidity of the overall unit.

The equipment and overall quality of the cabinets and tool roller/bench is great for the price. I was concerned about the weight of light hand tools etc. appose to buying another roller tool box but it ended up working out incredibly well. The garage has never been so organized.

Great storage cabinet. This is our second one - I use them to store my lapidary and craft items. It is very sturdy and well-built and the wheels make it even better. I love the fact that if I want to put it somewhere else, it just rolls to the new place. We do have them secured to the wall for safety. And note that it does take 2 people to assemble it.

Having bought about thirty more of your hanging cabinets, lockers, and rolling cabinets, to add to my older Seville Classic units that are about fourteen years old, my comments are how happy I am that you continue to make matching cabinets today. Additionally, I would like to see you make a turntable cabinet that can fit into the inside corners of a room. Your current line of cabinets create dead spaces at each inside corner. A properly designed turntable unit could also be used as end units if designed that way.

This was my first Sam's club purchase, I actually joined Sam's just to purchase this storage cabinet. I bought the cabinet for garage use, and it is just not sturdy enough for that purpose. For example, I aligned the doors, and just adding things to the shelves was enough to knock off the alignment of the doors. Also, the doors are advertised as "stainless", but a magnet still sticks to them - a magnet should not stick to *real* stainless steel. Depending on your intended use it may be fine (craft room or home office?), but don't expect to store anything of even modest weight or you will be disappointed. I would return it, but it was a bear to assemble, and would be impossible to put back into the box.