Works great to put all the drills and other cordless tools in then have all the charging stations below in the open areas. Only thing is I wish they had predrilled holes in the bottom for power cords to drop down through. I had to drill my own.

I am a professional designer and builder. Over the past years, I have purchased a number of the Seville Classics UltraHD Stainless Steel Items. My first experience with Seville was purchasing 2 of their gray wall cabinets for my own home's 2 car garage. That sold me on the product. I recently built a beautifully finished, ultimate man cave, 30'x40' garage/shop. I used numerous Seville pieces in that project. I like the quality, versatility,and appearance.They assemble and mount easily and provide great storage and work surfaces. Most recently, I purchased several Seville pieces for an office that I am building. I often wall mount these cabinets at counter height and cover the tops with a rubberized shelf liner material. It creates a narrow work surface and leaves the wall space open to hang peg board, etc., above the cabinets. I am obviously impressed, because I keep using Seville in my projects. Also, every time that I have shopped for Seville, Sam's Club has had by far the best price. That said, I will mention a few minor negatives. I can no longer purchase many of the Seville items, in any Sam's Club store near me. I now have to order them from the Sam's Club web site. These are heavy items. Unless one has a (free shipping) S.C "Plus" Membership, the shipping cost is quite expensive. One may in fact, find it more cost effective to upgrade to a "Plus" membership, than to pay for the shipping. Also when having them shipped, there is a greater chance of damage. As soon as they are received, we immediately open them and inspect every single part. With only being available on line, one cannot rush down to the local Sam's store for a replacement. Make sure that everything is OK before you start your project. One also needs to be aware that the Seville products, do not come with pre-cut shelf or drawer liners. One should never use metal cabinetry, without moisture proof liners. It prevents chemicals or rust from damaging the metal. All of the Seville items that I have received, come with an ID reference sticker, affixed to all parts, that corresponds to the assembly instructions. Also included is a long magnetized screw driver. I find however that an electric drill/driver, with a long extension bit, greatly reduces the assembly time. ( I hope this is helpful) D.B. Leesburg, Florida.

These shelve units went to gether very easy - I do recommend them. The only issue I found was when buying two the locks should have been keyed alike someone should have worked hard to either match the units or two matching locks should have been added to the order.

Excellent quality especially for the price. Easy to understand directions and well packaged. I do recommend buying the Seville products at your local Sam’s Club, if they are available as some of these products I’ve purchased in the past were slightly damaged/dinged up during shipping

This cabinet was easy to assemble and the screwdriver is included. I set the mounting brackets on the wall with the paper template. The location was perfect and level. The interior is roomy and functional. The doors close nicely with a magnet catch. The shiny doors give the cabinet a nice industrial look. I am pleased with the build quality.

I purchased one of these cabinets along with 5 of the single door cabinets for my garage. They all showed up in a timely manner, delivered by FedEx. The boxes all arrived in good shape. The cabinet parts were decently packaged wrapped in plastic them separated by styrofoam. I opened one box and lay the cardboard on the kitchen table to assemble the cabinet on top. This was WAY more comfortable than attempting to assemble on the floor. My first cabinet took me slightly over 30 minutes to assemble using only the supplied screwdriver. I thought about using an impact driver but the proximity of the screws to the inside edge of the cabinet and the thickness of the impact driver would make for a large angle into the screw head - with a 6" driver bit, you'd still be off at 15°-20° from straight. I was also initially worried about strength of the supplied screws - that proved to not be an issue. So - I assembled the perimeter of the cabinet using only the supplied screwdriver - left side to the top and bottom of the cabinet (face up) then flipped the cabinet to install the right side - this was easier for me keeping the screws on my left as I'm right-handed. Then, you attach the two rear panels - start all the screws, snug the corners and measure corner to corner to make sure the frame is square, then tighten all the rear panel screws. This is where the impact driver came in handy. There are 20 or so screws to secure the back panels. Attach the door/hinge to the frame and it's ready to hang. The door hinges are slightly slotted for adjustment - I recommend getting it close and make your final adjustment when the cabinet is hanging, as it may change slightly. The cabinets hang on a french cleat type system. I mounted two horizontal 2x4s on the wall with 3.5" lag screws into the studs in the wall - slightly countersunk with 1" fender washers so the top of the lag was below the surface of the 2x4. This allowed for many screws for mounting the hanging cleat into solid wood and not trying to use some sort of drywall anchors. The open shelf cabinet is wide enough to hit two studs but mounting the 24" wide single door cabinets would be a 1 or 2 stud for each cabinet depending on where they were in the order. The 2x4 method allows for a screw every 4" across the cleat. Once the cleat is mounted, it literally takes about 15 seconds to hang the cabinet on the wall. It took me about 3 hours to assemble 6 cabinets with a bit of sidetracking during. I think I said the first was slightly over 30 minutes - the second one was done in about 20 minutes. I was timing that one. I feel like the cabinets are substantial enough for general garage use. The mounting system seemed sturdy. The cabinet hardware proved to be tough enough to use an impact driver on. I did drill pilot holes into the 2x4s before mounting the cleats. The supplied wall screws are also phillips-head and the torque they accept is dependent on how hard you push the driver into them. I did not break any of them using an impact driver while driving them into the 2x4 but chose your pilot hole size accordingly. If the hole was too small (I worked my way up), the screw was very difficult to drive in and the phillips bit slipping in the screw head wasn't hard to do. Overall, I am VERY happy with the results of my install, the condition of the cabinets, the quality of the hardware and the value for what I paid. Time will tell on the durability - but I feel like for general home use, there should be ZERO issues with these cabinets. Additional note - the cabinets do have keyed locks - I saw in another review that you can't get them keyed alike. I'm sure you could probably find aftermarket lock cylinders to accomplish this if you really wanted to, but I took my keys and taped them under the shelf in each cabinet. I will NEVER lock my cabinets. They could probably be broken into with a screwdriver bending the door. The locks seem more like something to keep your small child out of your yard chemicals, but these are wall cabinets that should be higher than that small of a kid could reach anyway. These are not secure enough that I'd rely on the locks to keep valuables or say a gun secure.

Needed a medicine cabinet that locked because my daughter is a master at getting into things. There are no good options for exactly what I needed, so I branched out to cabinets like this one. It seemed like it might be too utilitarian at first, but once it was on the wall I was thrilled. The little shelf is great. The price is excellent. Love it!

This cabinet is great-exactly what we needed for the space. It came packaged very securely. However, it is still sitting in pieces in my living room floor because none of it comes assembled and I haven't had the time to take up an afternoon project. It strikes me as odd that with the time invested in packing it so nicely, the manufacturers could have just assembled it and the item would probably have taken up just as much shelf space.

Easy to assemble. Clear instructions. Very sturdy & easy to mount to wall. Highly recommended buy.

Sturdy, functional & easy assembly