We are home owners for about 6 years, very handy but not pros in the very least. Decided to rip out a bath and replace with a shower basin. It is Very small. Great for small or spare bathrooms. Not bad to install. It definitely took two people but for folks that have never installed a shower stall it was not a large project.

As above I remodeled bathroom on an older mobile home and space was at a premium. Instructions were sparse and not well thought out. Had difficulty with shower door, but the issue was resolved quickly and shower now installed and ready to use. This project requires good background on remodeling/building to complete.

Installed in a new studio. diy project. Contractor Tiled backsplash and even had an unlevel wall on bottom due to instlling tile over shower pan. However, because of the way the shower frame installs it is very forgiving.Tiny frame screw Washers and covers are mislabeled. Common sense fix

We are enjoying the nice shower and the rounded curves of the model. It did prove a bit challenging for my guy installing it because there’s a 1 inch lip that doesn’t allow the shower walls to sit flush against the actual walls. Therefore, he had to cut into the walls to push the shower walls as close and flush to the main walls as possible but the shelves are still flimsy and I don’t put a lot on them. Also found that you can’t properly caulk inside if you have both doors already installed. We did need to put shims underneath the doors where they connected to the shower pan because when the doors were open and close, it kept moving and pulling the caulking off the shower pan.

I bought this Nov.'20 but due to bad, unscrupulous 'contractors', I didn't get it installed til recently. I worried that the base looked smaller than I expected, but when doors were up, it looked much better. The one thing I don't like is that bases are still allowed to be made without non-slip surfaces. They should be required of ALL manufacturers of showers & bases. I wish OVE would switch to those for the safety of their customers. Bath mats don't always perform they way they claim & cause a person to fall.

beautiful shower stall - door glides nicely hopefully preventing door issues later - biggest gripe is the hardware ie:philips head screws - cheap - they stip easily - extremely difficult to place in channel as they are not hands free unless using a magnetic driver... even more fun removing (needle nose vice grips recommended) suggest replace with quality "robertson" head screws before starting. Also, when installing the mixer, remember the shower wall is 3/4" from your existing wall so accommodate accordingly

I bought this shower (with walls) to replace an older MAAX shower (of similar design) in my basement after its base cracked and some water leaked into the subfloor below. Besides the cracked base, there were other problems with the old shower, so I decided the whole thing needed replaced. I'm somewhat handy, so I wanted to do as much of the tear-out and installation as possible by myself. The base of this new shower appeared thicker and sturdier than the old unit, so it gives me some confidence it will last longer. The drain location for this unit is near the corner whereas my old shower had the drain in the center. This required the drain pipe underneath the shower to be moved a foot or so. I opted to hire a handyman to move that drain pipe (which involved chiseling away a bunch of concrete) and get the base of the shower installed. Beyond that, I finished the rest of the installation myself. This occasionally required the help of my wife to hold something in place for me, but 95% of the time I worked alone. I like the glass enclosure versus my old plastic one. The two large glass pieces were a little heavy to maneuver during installation, but the door operates very smoothly and seems really sturdy. Overall, this shower seems built of higher quality materials than my old one, and I really hope it lasts.

I was skeptical about a pre-fab shower looking cheap. However, this product and the finishes were surprisingly better than I expected and look like a more quality product. Have a few more minor things to seal up everything before we start using but excited to do so

Bought at Home Depot and installed myself. Instructions were clear (they did miss 1 step though that should be between steps 13 & 14: screw frame (L) to wall frame (E) with provided self- tapping screws). I figured that out quickly because shower moves around when doors close otherwise!! Also, TRY TO HAVE STUDS BEHIND THE CORNERS WHERE YOU SCREW THE SHOWER FRAME TO THE WALL!! They provide Ct rap plastic wall anchors (step 6&7) but two pulled right out so I used thicker screws that I had lying around). It’s a simple pretty and functional unit. Installation is a 2 person job. But great unit

HAPPY. I bought this is February when I was starting to finish my new bathroom. I have installed the base and can attest as a home owner and retired contractor, that the base is very high quality. The rest of the parts and glass pieces look really good but I can't attest to the fit and operation yet.