I installed these on two Toyotas, a Corolla and a Highlander in early November '23. Both have the same J-hook mounting bracket that is supposed to just click into place with no additional adapters. Installed without incident. Then yesterday we had our first real winter weather, a rain and snow mix. Driver's side wiper came off of the Highlander as I pulled into a garage. My wife's Corolla completely lost the passenger side wiper while she was driving in the worsening weather! Scary. So I tested the remaining wipers on each car and found that I could pull them off the J-hook with little effort. They had clicked into place securely a couple months ago so apparently they are either defective or they just can't stand up to early winter weather. I couldn't trust these wipers any more so I bought some with a cover that locks down over the mount area after sliding the wiper into place.

The Ford Escape uses 28" blades. These fit and went on fine. The issue is that the blades don't have enough tension to them, and the bottom 1/3 of the Drivers side blade doesn't make contact. The blades I removed had far more spring/tension and both made contact all the way through

Brought the 18" and 26" home to install on the car. 26" installation went fine, but the 18" was missing the "B" adapter (19mm push button adapter). Drove back to Sam's to return, only to find that the replacement 18" was also missing the "B" adapter. Went through their entire bin of about 20 18" packets and could see through the packing that they were all missin the "B" adapter. Looked at the 19" and 17" -they all had it. So for some reason only the 18" was missing it. Not sure if that's a manufacturer defect, or if someone went through and snagged them. Either way, that ding on quality control by Sam's, but the blade themselves seem to be fine. Full contact all around (at least for now).

This is not good wipers blades, not cleaning well

Not good

Junk, don't last.

Wrost

Great experience

not good for the money

Fantastic!