The unit shipped within a week and was easy to set-up. I've already cleaned my house and driveway and they look brand new again. Good quality machine at a fair price.

This is a very nice pressure washer. I bought it not only for the Simpson brand but also because it had a Kohler engine. I already own a Simpson 3400 PSI with a Kohler engine and it works great. I wanted something smaller as well but it had to have a Kohler engine. Once I saw this one, I did not hesitate with my purchase.

Easy to use, powerful, efficient

Works as advertised. Easy to start!

American assembled and good quality

The pull rope is too long. It makes it difficult to hold the machine and pull to start. You have to release the pressure if it almost cranks.

[This review was collected as part of a promotion.] works great but why ship only 12oz of oil when the engine calls for 20

Warning: the 12 oz bag of oil that comes in the box was not enough to reach low mark, had to get more oil to fill properly. Fired right up on 2nd pull. Not most powerful, but good value for the money so far.

When unboxing my Simpson MegaShot Kohler XTX675 (MS61114) purchase at Sam's Club, it was immediately noted that the siphon tube with filter was missing that Sam's Club says should have been included in the box. Hmm, okay… I guess I will have to call Simpson on getting that part. Next, when trying to install the handle on to the pressure washer's frame tubing it was discovered that the frame tubing holding the engine and pump was misaligned by nearly 3/4 of an inch. Upon trying to install and torque the handle I may have actually bent the handle's tubes getting it to flex that much to fit into the frame's tubes. At minimum it is bowed out of shape. Next, following the Spray Gun Holster installation instructions (separate piece of paper in the box), I mounted the spray gun holster to the handle in the only place it could possibly be mounted (see photo of instructions). On inserting the spray gun into the holster, the spray gun runs straight into the Kohler engine's air filter housing. To make the holster even sort of work at holding the spray gun, the gun's nozzle must be left resting on top of the air filter housing at a strange angle in the holster (see photos). At this point, I can only assume that I received the wrong spray gun holster for this model of Simpson pressure washer, or maybe the torqued frame and handle are the cause? Lastly, using the bag of 10W-30 oil I filled the engine crank case squeezing out every last drop of oil from the bag I could. I let the oil settle a minute. I then checked the oil level. It is only at around 3/4 full. Wiping the dip stick clean, and being sure to twist the oil cap closed, I re-inserted the dip stick into the crank case and checked it again. Nope, it is still the same level. Now I have to go and purchase more 10W-30 oil before I can even try cranking the engine. So far, I am not impressed. I can only hope at this point that the pressure washer actually works better than the overall fit, finish and quality of the pressure washer so far. Review to be continued… maybe?

Used for the first time and it does not draw soap out of the soap tank. Had to take in for warranty after first use. Very disappointed.