Assembly of this mower is not all that difficult but some of the pieces are cheaply made and seem a bit both flimsy as well as the plastic handle bolts "strip" so that the plastic comes off of the actual bolts leaving a very long bolt sticking out from the handle and a hazard to one's legs. It also won't tighten very securely and thus remains quite loose, so I had to go get different bolts to use in place of them. This is all before the lawnmower was ever even started up for which it was purchased.

ok,parts missing when delivered. a good machine for a flat lawn,will not cut tall grass,I would not buy this unit,spend a bit more and get a better unit.i bought this unit ,it said made in USA... it is made in Mexico! it does run well,the air filter clogs easy,u have to clean often,u cannot,lift it up to cut tall grass,it will kill the engine,will not cut on a slope.

it doesn't come with any tools to assemble the bolts. my boyfriend had a very hard time putting it together . if they had added 2 wrenches for the bolts to the handles, it would've at least been better. its trial and error to find the right size bolts. it's just too inconvenient. also, there's oil that was leaked on it, not even sure how that happened because the oil it came with wasn't open. it's almost like trying to put something together from IKEA with their half directions 🤔

I wanted the lightest lawn mower I could find. Im 66 and only 4'10. Easy pull. I thought the orange clips on the side was to adjust handle but it not adjustable. A little tall for me but easy to do flat areas. Hills forget it. The height adjustment for cutting is not convenient for u set the hgt adjustment before u attach wheel. So I put it in the middle, attached wheels and had to take wheels off again to lower mower deck

It is a handsome-looking machine, but it is more basic than I was expecting. First of all, the three cut heights that are possible must be adjusted by removing the wheels and re-positioning them. I never would have purchased a machine without real-time height adjustment capability if that distinction were described clearly. I chose the middle opening initially, but I am prepared to raise the deck by inserting in the lowest hole all around. Second of all, the rear wheels do not sit proud enough with respect to the deck; so the handle presses hard against the right-rear wheel at almost all times unless you push hard upward while you mow. I seem to push downward naturally, so my wheels were dragging against the grass. I corrected the problem by inserting some spacers between the wheel and the deck; three washers fit and provided enough clearance. Now I can enjoy the work much more. You will notice that the oil dipstick seals with a rubber ring, rather than a thread; and I can imagine needing to replace this seal periodically, as oil is terrible on rubber. The most positive aspect is the ease of starting; three pumps and a pull are all that are necessary. The cut is clean, but I want a wider cut. Therefore, I am inclined to place this engine on a wider deck and gain better advantage of the 140+ horsepower.

I bought this mower this spring. It vibrates so bad have already had to replace the blade. One wheel broke off today and can not be put back on because it actually broke the frame where the bolt went. The top cover has vibrated off. It starts easily is about the only good thing.

The mower is surprisingly light. Not heavy duty. It will require some mechanical ability and tools to assemble, plan on a couple of hours unless you are on a pit crew. Some details required figuring out since the instructions are sparse and small. Pull cord does not attach to handle as shown. Don't store off horizontal since the oil will burn off through the cylinder. Operates at one full speed, not adjustable. Overall worth the money.

I have had this lawnmower less than 3 months. I was mowing and noticed that something flew across the yard. I stopped to see what it was. It was the front wheel and it broke completely off the frame. I am not able to use the lawnmower now. Not a happy customer.

After one run through of the back yard, the left wheel fell off. I found one piece of hardware, but the nut is lost forever. I crawled on hands and knees, and couldn’t find it. I ordered better wheels and hardware that should be here soon. This was a Father’s Day gift, and it has turned into a burden.

very nice mower i would recommend it the only thing i can see them changing there is no wheel adjustment so when you out the wheels on you either got the lowest holes / medium or high i went with the medium in the middle and it cuts my grass the perfect height for me.... other then that i definitely recommend senix