We are enjoying the nice shower and the rounded curves of the model. It did prove a bit challenging for my guy installing it because there’s a 1 inch lip that doesn’t allow the shower walls to sit flush against the actual walls. Therefore, he had to cut into the walls to push the shower walls as close and flush to the main walls as possible but the shelves are still flimsy and I don’t put a lot on them. Also found that you can’t properly caulk inside if you have both doors already installed. We did need to put shims underneath the doors where they connected to the shower pan because when the doors were open and close, it kept moving and pulling the caulking off the shower pan.

I bought this shower (with walls) to replace an older MAAX shower (of similar design) in my basement after its base cracked and some water leaked into the subfloor below. Besides the cracked base, there were other problems with the old shower, so I decided the whole thing needed replaced. I'm somewhat handy, so I wanted to do as much of the tear-out and installation as possible by myself. The base of this new shower appeared thicker and sturdier than the old unit, so it gives me some confidence it will last longer. The drain location for this unit is near the corner whereas my old shower had the drain in the center. This required the drain pipe underneath the shower to be moved a foot or so. I opted to hire a handyman to move that drain pipe (which involved chiseling away a bunch of concrete) and get the base of the shower installed. Beyond that, I finished the rest of the installation myself. This occasionally required the help of my wife to hold something in place for me, but 95% of the time I worked alone. I like the glass enclosure versus my old plastic one. The two large glass pieces were a little heavy to maneuver during installation, but the door operates very smoothly and seems really sturdy. Overall, this shower seems built of higher quality materials than my old one, and I really hope it lasts.

We bought this to install in a cabin. It comes with 3 separate instruction books. One for the base, one for the walls and one for the doors. I recommend reading all three books first because they overlap on instructions and don’t always say the same thing. It’s a bit confusing at times. Overall- it’s worth the difficulty, because it is beautiful! Can’t wait to finish the rest of the renovation.

We just had this shower installed It is beautiful. The doors slide easily. The floor is solid. It fits in a smaller bathroom which we have fitted into a corner on the back porch mud room. Our installer felt that this was an easier install than similar kits.

I completed a DIY installation of this shower kit in a very small bathroom at my 100+ year old cabin in Estes Park, CO. I installed the shower as a replacement for a clawfoot tub that took up too much space. I ended up using the shower base and glass enclosure but not the acrylic wall panels since the walls were too out of plumb. The instructions that came with the kit were generally clear and complete though a few details were omitted (e.g., need to drill pilot holes for installation of the frame to the wall tracks). The quality of the shower base and enclosure were very good. However, the phillips-head screws that came with the kit were soft and easily stripped so I bought hex-head screws that I used instead. I have not used the shower yet but I am very happy with the quality and appearance of the new shower.

We are home owners for about 6 years, very handy but not pros in the very least. Decided to rip out a bath and replace with a shower basin. It is Very small. Great for small or spare bathrooms. Not bad to install. It definitely took two people but for folks that have never installed a shower stall it was not a large project.

We bought the 32inch version (without the walls since our shower is already tiled). This totally upgraded the looks and added a sophisticated modern touch. The glass doors are smooth to slide, and the height is just right. The manual is slightly confusing about installation but our contractor could figure it out. I totally recommend this product.

We have a small bathroom and this unit was a great replacement for our 32” square shower enclosure. The assembly went smoothly. The side walls are secured to the house by screws at the juncture of the dot framing. It has not been a problem but surprising at the lack of attach points. The glass pieces weigh about 40 pounds each. The instructions for the base install calls for cement and I would recommend it. I think there would be soft spots in the shower floor without it.

As above I remodeled bathroom on an older mobile home and space was at a premium. Instructions were sparse and not well thought out. Had difficulty with shower door, but the issue was resolved quickly and shower now installed and ready to use. This project requires good background on remodeling/building to complete.

Installed this month. The instructions aren’t super clear but we figured it out eventually. Sometimes with trial and error. They also don’t tell you until you see the instructions that you need to install it on drywall not studs and that you need 1x3’s to build a support.